Vigor2912 Series User’s Guide
147
Enable – Check it to enable DHCP Option. Each DHCP
option is composed by an option number with data. For
example,
Option number:100
Data: abcd
When such function is enabled, the specified values for
DHCP option will be seen in DHCP reply packets.
Interface: Specify the WAN/LAN interface(s) that will be
overwritten by such function.
Next Server IP Address/SIAddr – Type the IP address of
PXE server which is helpful for downloading boot loader
via network.
Option Number – Type a number for such function.
Note: If you choose to configure option 61 here, the
detailed settings in WAN>>Interface Access will be
overwritten.
DataType – Choose the type (ASCII or Hex) for the data to
be stored.
Data – Type the content of the data to be processed by the
function of DHCP option.
Inter-LAN Routing
Check the box to link two different subnets (LAN1 and
LAN2).
After finished the above settings, click OK to save the settings.
To Next Page
Loading...
Need help?
General
