EasyManua.ls Logo

DreamCast AURA36-CFB60 - Turning Off the Fire Pit

Default Icon
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
Operating Instructions
3. Push in the control knob, which will send gas to the pilot light.
4. While still pushing in the control knob, ignite the pilot light
using your barbecue lighter.
Depending on how long it has been since the fire pit was last used,
ignition may take multiple attempts until air is purged from the system.
5. After the pilot lights, keep the
control knob pushed in about 20 to 30
seconds to warm up the thermocouple
and ensure that the flame stays lit.
In exceptionally cold or wet conditions, the
thermocouple can require additional time to reach the required temperature.
6. Release the control knob. If the pilot does not remain lit, wait
5 minutes, then repeat steps 2 to 6 of the ignition process.
If the pilot will not light after multiple attempts, refer to the
troubleshooting guide on page 16.
Pilot Flame Check:
The pilot flame should envelop the thermocouple tip
by 3/8" to 1/2".
The pilot flame should be mostly blue and burning
smoothly. If the flame is yellow, flickering or waving,
excessively large or too small, turn off the fire pit and
consult the troubleshooting guide.
LIGHTING THE MAIN BURNER
1. Rotate the control knob slowly towards
the “On” position to light the fire pit.
If the main burner does not light or the flames are
irregular, turn the control knob to the “Off” position
and refer to the troubleshooting guide on page 20.
2. The flame height can be adjusted during operation of the fire pit
by adjusting the control knob between the “Pilot” and “On” positions.
HOW TO TURN OFF YOUR FIRE PIT
1. Rotate the control knob to the “Pilot”
position to turn off the main burner.
CAUTION: THE PILOT WILL REMAIN
LIT IN THIS POSITION
DO NOT COVER THE FIRE PIT WHILE THE PILOT IS LIT.
2. Rotate the control knob to the “Off” position
to completely turn off the fire pit.
3. Close the main gas control valve to the fire
pit.
After turning off the fire pit, allow a
5 minute shut-down period before relighting.
ALLOW THE FIRE PIT TO COOL COMPLETELY BEFORE
COVERING WITH ANY COVER.
WARNING: Failure to follow these instructions could result in fire or
explosion, which could cause property damage, personal injury or death.
3/8" to 1/2"

Related product manuals