9
Assembly Instructions - Overview
1. Position Fire Pit
Position concrete fire pit according to the Clearance
Requirements and Gas Supply location on pages 7 & 8.
2. Identify Parts & Assembly
Identify all parts on the Parts List on page 10 and
familiarize yourself with the assembly diagram for your
fire pit.
3. Assemble Fire Pit
Follow the assembly instructions on the following
pages.
4. Leak Test
Carefully leak test all connections.
5. Lighting Test
Test lighting of the firepit, following the operating
instructions on page 15-16 and observe the flame
pattern of the pilot and burner.
6. Install Fire Pit Media
Follow the instructions on Page 14.
7. Final Test
Test once more to ensure that the media installation
has not affected the burner operation.
⚠ WARNING
Failure to position parts in accordance
with these diagrams and instructions
and/or failure to use parts specifically
approved for use with this appliance
may result in property damage or
personal injury.
⚠ CAUTION
Do not remove the data plate attached
to the Concrete Fire Pit. This plate
contains important information.
NOTICE
Installation and repair should be done
by a qualified service person. The
appliance should be inspected before
use and at least once annually by a
qualified service person. More frequent
cleaning may be required as necessary.
It is imperative that controls, burner and
circulating air passageways of the
appliance be kept clean.
To Next Page
Loading...