17
Clean the Mopping Module
1. Press the two release clips on the side of the water tank, remove the mopping
module, and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean with only water and leave out to air dry before
re-installing.
Note: Do not expose the tank to the sun directly.
3. Clean the mop pad with water only and leave to air dry before re-installing.
Note:
Remove the pad from the mopping module before cleaning it, and make sure dirty
water does not flow back into the water outlet to avoid clogging.
For optimal performance, it is recommended to replace the mop pad every 3-6
months.
To Next Page
Loading...
