17
3. Clean and dry the mop pad.
Note:
Remove the pad from the mopping module before cleaning it, and make sure dirty
water does not flow back into the water outlet to avoid clogging.
Do not press too hard on the mop pad, as this can hinder its performance.
Pad should be cleaned before each use It is recommended to change the mop pad
every 3 to 6 months.
4. If slow water flow occurs, or the volume is not well-distributed, please clean the air
hole in the cover of the water tank.
Main Brush
1. Flip the vacuum-mop over and pinch the clips to remove the main brush guard. Lift
the main brush out of the vacuum-mop, then clean the brush bearings.
2. Use the included brush cleaning tool to remove any hairs tangled on the brush.
To Next Page
Loading...
