Dreame R10 - How to Use

8
EN
HowtoUse
Method2:ContinuousCleaningMode(TriggerSwitchLock)
Click the trigger switch lock to switch to Continuous Cleaning Mode when the vacuum is
running. Then release the on/off switch to make the vacuum in Continuous Cleaning Mode.
Use the trigger switch lock to free your fingers and avoid finger fatigue caused by holding the
switch.
Note:
•
In this mode, the lock indicator will illuminate steadily.
•
Click the trigger switch lock again to quit the Continuous Cleaning Mode.
Working Methods
Method1:DiscontinuousCleaningMode
Press and hold the on/off switch to power it on, and release it to stop immediately.
Select from two working methods for the vacuum, based on your needs.