12
EN
Installation Instruction
Note:
Ensure that the water hookup kit is well attached and cannot be removed
from the base station to avoid the risk of water leakage.
3. Wiping water on the O-ring helps to install
Ⓓ
and
Ⓔ
.
2. Tighten the 2 xing screws by a screwdriver to x the water hookup kit to
the base station.
4. Install the
Ⓓ
and
Ⓔ
until they click into place.
Note:
·Make sure the
Ⓓ
and
Ⓔ
are installed securely in place and cannot be pulled out.
·The round button on the parts is the release button, do not press it during
installation.
Used Water Pipe
Adapter Assembly
Ⓔ
Clean Water Pipe
Adapter Assembly
Ⓓ
Click
To Next Page
Loading...
