24
EN
Disassembly Instruction
6. Loosen the 2 xing screws with a screwdriver until the clean/used water
tank
Ⓐ Ⓑ
can be removed from the base station. And then reinstall the
small cover which was removed during installation.
3. Press the snap ring at the joint and pull out the elbow
Ⓕ Ⓖ
forcefully. Use
a container to catch the water owing out.
4. Hold the round button to pull out the clean/used water pipe adapter
assembly
Ⓓ Ⓔ
forcefully, and disconnect all connections.
5. Use a monkey wrench to remove the 3-way diverter valve
Ⓗ
. Reinstall the
plug/faucet which was removed from the water source.
To Next Page
Loading...
