9
EN
1. Open the upper cover, take out the clean water tank and used water
tank. Remove the label sticker inside the base station.
2. As shown in the Step ① , insert the power connector of the main unit.
In the Step ② , place the main unit downwards and align to the water tank
connectors inside the base station, in order to insert the clean water
pipe Ⓜ and used water pipe Ⓛ .
Installation Instruction
❶ Install the Main Unit
Label Sticker
Water Tank Connectors
①
②
Align the main unit to
this place
To Next Page
Loading...
