10 11
ENEN
1. Remove the protective strips
2. Install the side brush
Click
Before Use
Connecting with the Dreamehome App
Note: If your robot cannot connect to the app successfully, reset the Wi-Fi and add the
device again.
Note: Install the side brush until it clicks into place.
1.Download the Dreamehome App 3. Reset Wi-Fi
Scan the QR code on the robot, or search "Dreamehome" in the
app store to download and install the app based on your needs.
Simultaneously press and hold the buttons and until you
hear a voice say, “Waiting for the network configuration.” Once the
Wi-Fi indicator is blinking slowly, the Wi-Fi has been successfully
reset.
Wi-Fi Indicator
·
·
·
Under the
Cover
2.Add Device
Open the Dreamehome app, tap " " in the upper right, and then
scan the QR code above again to add "DreameBot D10s Plus".
Please follow the prompts to finish the Wi-Fi connection.
Only 2.4 GHz Wi-Fi networks are supported.
Due to upgrades in the app software, the actual operations may be dierent from the
statements in this manual. Please follow the instructions based on the current app
version.
Note:
3. Connect to a power outlet and start charging
Note:
Keep the immediate area 1.5 m in front of the base and 0.5 m to its both
sides clear of objects.
Make sure that no objects might block the signaling area.
Place the base on level ground against the wall and connect it to
a power outlet. Place the robot onto the base to charge. The robot
will turn on automatically and begin charging. It is recommended
to fully charge your robot before first-time use.
About the Auto-Empty Base
> 0.3 m
> 0.5 m
> 0.5 m
> 1.5 m
To Next Page
Loading...
Need help?
General
