Note: It is recommended to fully charge the robot before its first use. When the robot cannot be turned on after
the battery is depleted, manually connect the robot with the base station to charge it.
6. Install the Cleaning Solution Bottle
Remove the cap of the cleaning solution bottle, and tear off the two seals on the bottle as shown in the figure.
Open the upper cover of the base station and install the bottle along the slot into place. The cleaning solution
will be added automatically while working.
Note: Do not add any liquid other than the officially-approved cleaning solution, otherwise it may cause base
station malfunction.
7. Add Water to the Clean Water Tank
Take out the clean water tank from the base station, and fill it with clean water up to the max water line. Then
install it back into the base station.
Connecting with the Dreamehome App
1. Download the Dreamehome App
To Next Page
Loading...
