15 16
ENEN
2. Reinstall the dust cup.
Installing the Filter
1. Insert the lter into the vacuum and
gently press down, as illustrated.
Care & Maintenance
2. Use scissor to cut o the hairs and
bers that get stuck on the brush. Wipe
the dust from the notch and transparent
cover with a dry cloth or paper towel.
Thoroughly dry before use.
Cleaning the Smart Multi-Surface Brush
1. Turn the lock counterclockwise until
it stops, then remove the brush roller
from the brush.
4. Allow the filter to air dry for 24 hours.
12
6
111
57
210
48
39
24 hrs
Cleaning the Filter
3. Clean the lter with clean water.
Make sure you rotate the lter 360° to
thoroughly and remove all dust caught
in the lter. Lightly tap the lter several
times to remove any excess dirt.
• It is recommended to clean the filter once every 4 to 6 months.
• Only use clean water to wash the filter. Do not use detergent.
• Do not attempt to clean the filter with a brush or finger.
Note:
2. Remove the lter from the vacuum by
pulling it down in the direction shown
in the gure.
1. Remove the dust cup as shown in the
gure.
2
1
Care & Maintenance
To Next Page
Loading...
