13 14
ENEN
Installing the Dust Cup, Pre-Filter, and Cyclone Assembly
1. Insert the cyclone assembly vertically into the dust cup, and make sure that the handle
of the cyclone assembly line up with the slot on the left side of the dust cup. Turn the
handle clockwise until it locks, then ip the handle down.
2. Place the pre-lter with its front side facing up into the cyclone assembly.
3. Slightly tilt the dust cup so its slot aligns with the clip on the vacuum. Then gently push
the dust cup until it clicks into place.
3
1
2
3
Care & MaintenanceCare & Maintenance
3. Remove the pre-filter first, then lift the handle of the cyclone assembly and turn it
counterclockwise until it stops, then pull to lift out the cyclone assembly.
Note: It is recommended to clean the pre-filter at least once every 3 months and the
cyclone system at least once every 6 months.
1
2
3
Pre-FilterCyclone Assembly
4. Wipe the dust cup with a soft wet cloth. Pay attention to wring out the discloth before
using.
5. Rinse the cyclone assembly and pre-lter until they are clean. After washing, air dry for
at least 24 hours.
12
6
111
57
210
48
39
24 hrs
To reduce the risk
of electric shock, do
not rinse the dust
cup with water.
To Next Page
Loading...
