6 7
Installation
Vacuum and Accessories
Installation Diagram
Installation
Installing the 2-in-1 Charging & Storage Mount
1. The 2-in-1 charging & storage mount is an optional accessory. You can install it
based on your requirements.
2. The mount should be installed in a cool, dry place near a power outlet, out of
direct sunlight, and away from moisture-prone areas, such as a kitchen.
3. Securely install the mount by using mounting hardware suitable for the type of
wall selected. Make sure the installation area is clear of any pipes such as gas or
water lines, and air ducts, electric wires and cables, or drainage lines.
4. It is recommended to hire a professional to install the mount and to use protective
clothing, goggles, and other protective equipment where necessary.
5. Using an electric drill, mark and drill two 8 mm diameter holes into the wall where
desired to a depth of about 30 mm. Insert the wall plugs into the holes, position the
mount, then fasten it to the wall with the included screws.
106 cm
To Next Page
Loading...
Need help?
General
