14 15
Care & Maintenance Care & Maintenance
Tips:
1. Always use genuine parts to keep your warranty from being voided.
2. If the lter or nozzle becomes clogged, the vacuum cleaner will stop working
shortly after being turned on. To restore functionality, clean the lter or nozzle.
3. If the vacuum cleaner will not be used for an extended period, fully charge it,
unplug its power adapter, and store it in a cool, low-humidity environment away
from direct sunlight. To avoid over-discharging the battery, recharge the vacuum
cleaner at least once every 3 months.
Cleaning the Vacuum Cleaner
Wipe the vacuum cleaner with a soft dry cloth.
Cleaning the Dust Compartment
Before cleaning the dust compartment, disconnect the adapter and keep the
vacuum cleaner's power switch in the off position. The vacuum cleaner's cleaning
ability will be reduced if the dust compartment is lled to the "MAX" mark. To regain
performance, empty the compartment.
1. To empty the dust compartment: Press the release button on the bottom of the
compartment, then empty its contents.
2. Clean the dust compartment: Use a dry cloth or paper towel to wipe the dust from
the inner wall of the dust compartment.
1. Rotate the cyclone assembly in the direction illustrated to unlock it, then remove
the cyclone assembly.
Note: Remove Cyclone Separator from the housing by turning in the direction as
shown in the diagram for a thorough cleaning.
2. Rinse the cyclone assembly with water until it is clean. Thoroughly dry the cyclone
assembly.
Note: Keep it in a ventilated or cool place for at least 24 hours.
2
3
1
12
6
111
57
210
48
39
24 hrs
Cleaning the Cyclone Assembly
To Next Page
Loading...
Need help?
General
