16 17
1. Place the vacuum cleaner securely on a flat surface, then turn the HEPA lter
assembly cover in the direction indicated and remove the HEPA lter assembly.
Note: Remove the built-in foam pad before cleaning the HEPA lter assembly. Rinse
the HEPA lter and foam pad with water.
2.Rinse the HEPA lter and foam pad with water. To thoroughly remove all dust
caught in the lter, rotate the HEPA lter by 360 degrees while rinsing. Lightly tap the
lter against a sink several times to remove any excess debris. Keep the HEPA lter in
a well-ventilated and cool place to fully dry.
Note: Fully dry the lter (at least 24 hours) before reinstalling it.
1
2
3
3
12
6
111
57
210
48
9
24 hrs
Cleaning the Soft Roller Nozzle
1. Push the brushbar head release
button in the direction of the arrow until
the cover of the brushbar head pops to
open, then remove the brushbar head
by lifting it in the direction indicated.
2. Use scissor to cut off the hairs and
bers that stick on the brushbar head.
Wipe the dust from the notch and
transparent cover with a dry cloth or
paper towel.
3. When it is dirty, rinse the brushbar
head with clean water until it is clean.
4. Stand the brushbar head upright for
at least 24 hours until it is fully dry.
12
6
111
57
210
48
39
24 hrs
Care & Maintenance Care & Maintenance
Cleaning the HEPA Filter Assembly
To Next Page
Loading...
Need help?
General
