Dreamline PRISM PLUS - Enclosure Installation: Brackets and Stationary Glass; Securing U-Channels and Installing Brackets

7PRISM PLUS manual Ver 1 Rev 2 11/2016
1
Fig 3
Fig 4
1
2
3
4
5
1
Ø5/16"
(8mm)
Left-swing door installatiion shown for example
Fig 5
outside
inside
3. Mark the drilling holes on the wall through the predrilled
holes in the Stainless Steel U-channels (#11) .
Drill the holes in the wall using Ø 5/16”(8mm) drill bit and
insert the Wall anchors (#07).
Run a bead of Waterproof silicone along the back of the
Stainless Steel U-channels (#11) .
Fasten the Stainless Steel U-channels (#11) to the wall
using the Round head screw ST4.2×40 (#17).
See Fig 3 for details
5. Set the Stationary Glass 2 (hinge panel)
(#03) onto the threshold and into the Stainless
Steel U-channel (#11).
See Fig 5 for details
4. Install both of the Bottom Brackets
(#12) onto the panel glass (#01) &
(#03). Use the included gaskets to
protect the glass.
See Fig 4 for details