Stage
3a
Page 5 of 8
i:
ii:
iv:
iii:
G
U
Adjustable
Foot
5
E
V
F
G
FITTING WOODEN SLAT SET
G x7
F
V
Carefully lay wooden slat set (5) on the metal supports
on each side panel.
Fit centre slat with the support leg (6) using
screw (U) and flat washer (G). Fully tighten
using a cross-head screwdriver.
Carefully turn adjustable foot
clockwise until it just touches
the floor and slat is horizontal.
x6
x6
E
U
x6
x1H x1
Fitting Slats - Use Pack 'B'
5
E
V
F
G
5
6
E
V
F
G
Roll out rest of wooden slats and
fix with last two bolt sets fully
tighten using Allen key (H) .
Using two bolts (E) with
spring washers (V), flat
washers (G) and sleeve
nuts (F) fix one slat next
to headboard.
Roll out wooden slats just
over half way down the bed
and using two more bolt sets,
loosely bolt the central slat
into position - align slats and
fix all four bolt sets 100% by
Allen key (H).
5
To Next Page
