Dremel 1100 - Speed Settings

-15-
* Speed for light cuts; Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Speed Settings
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
100, 121, 131 10 10 4-6 4-6 10* - - -
114, 124, 10 4-6 2 4-6 4-6 - - -
134, 144
190 10 10 2 10* 10 - - -
118, 191, 192, 10 10 2 4-6 10 - - -
193, 194
116, 117, 10 4-6 2 4-6 4-6 - - -
125, 196
115 10 10 2 4-6 4-6 - - -
198 10 10 2 4-6 4-6 - - -
199 10 10 2 4-6 4-6 - - -
High Speed Cutters
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
105, 108 10 10 10* 2 4-6 - - -
106, 109, 10 10 4-6 2 4-6 - - -
107, 110 10 10 4-6 2 4-6 - - -
111 10* 10* 10 2 4-6 - - -
112 10* 10* 4-6 2 4-6 - - -
113 10* 10* 4-6 2 4-6 - - -
Engraving Cutters
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
7103, 7105, 10 10 - -
-
10
10 10
7117, 7120,
7122, 7123,
7134, 7144
Diamond Wheel Points
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
9931, 9932, 10 10 2 - 4-6 - - -
9933, 9934,
9935, 9936
Structured Tooth Tungsten Carbide Cutters
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
9901, 9902, 10
10 2
10 4-6 10 10 10
9903, 9904,
9905, 9906,
9912
9909, 9910 - - - - - 10 10 10
9911
Tungsten Carbide Cutters
BM 2610951850 08-07 8/15/07 3:50 PM Page 15