the accessory to no longer run true and concentric
Turn the tool by hand and observe if there is any
With the shaft lock engaged, tighten the chuck
using the EZ Twist nose cap or wrench to secure
the accessory.
that the accessory is straight before repeating the
BALANCING ACCESSORIES
loosen collet nut and give the accessory or collet a 1/4
You should be able to tell by the sound and feel if your
ATTACHMENTS
•
225
• Comfort guard attachment to protect you from dust and
550
• Multipurpose cutting kit for controlled cutting in a
565/566
•
568
•
575
•
576
• Detailer’s grip to have even better control of the tool
577
•
675
•
678
•
*) When using a new exible shaft for the rst time, keep it
in a vertical position for two minutes with the tool running
at high speed.
NOTE: Not all attachments listed above are standard
included with the tool/kit
USE
GETTING STARTED
HOLDING THE TOOL
Always hold the tool away from your face. Accessories
they come up to speed.
When holding tool, do not cover the ventilation
openings with your hand. Blocking the ventilation
openings could cause the motor to overheat.
Aa
As
ON/OFF
ELECTRONIC FEEDBACK (4000/4250/4300)
also helps to keep the preselected speed virtually constant
VARIABLE SPEED SLIDE SWITCH (3000)
The speed may be adjusted during operation by sliding the
To select the right speed for each job, use a practice
piece of material.
VARIABLE SPEED DIAL (4000/4250/4300)
may be adjusted during operation by presetting the dial on
To select the right speed for each job, use a practice
piece of material.
OPERATING SPEEDS
Ad
Wire brush setting (4250/4300)
Most jobs can be accomplished using the tool at the highest
23
To Next Page
Loading...
