Dremel 8220 - Speed Settings (Continued); Flapwheels and Buffs Speeds; Detail Brushes, Drill Bits, and Grout Removal Speeds

30
Speed Settings (Continued)
Note: Each number settings listed in the speed charts = x 1,000 RPM
* Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Flapwheels
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
502, 503, 504, 505 25-35 18-24 5-8 25-35 18-35 - - -
Finishing Abrasive Buffs
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
511E, 512E 12-17 12-17 9-11 12-17 12-17 - - -
Detail Abrasive Brushes
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
EZ471SA,
EZ472SA,
EZ473SA
5-17 5-17 5-17 5-17 5-17 - - -
Drill Bit
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
150 25-35 18-35 5-11 - 12-17 - - -
Glass Drilling Bits
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
662DR, 663DR - - - - - 5-17 5-17 5-17
Grout Removal Bits
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
569, 570 For use on wall and floor grout - 12-24 -
1600A012FX.qxp_8220 1/30/17 12:42 PM Page 30