Dremel 8220 - Speed Settings (Continued); Cutting Accessories and Polishing Speeds; Wire Brushes and Sanding Discs Speeds

29
Speed Settings (Continued)
Note: Each number settings listed in the speed charts = x 1,000 RPM
*
Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Chain Saw Sharpening Stones
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
453, 454, 455 - - - 25-35 - - - -
Cutting Accessories
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
409, 420, 426, 540,
EZ409
- - 5-11 25-35 25-35 25-35 25-35 -
543, EZ544 25-35 18-35 5-11 - - - - -
545, EZ545 18-35 18-24 - - - 12-24 12-24 -
560
For use on drywall. For best results, use at 30,000 rpm
561 12-35 12-35 5-11 - 25-35 - - -
562 - - - - - - 25-35 -
EZ456 - - - 25-35 25-35 - - -
EZ476 - - 5-11 - - - - -
Polishing Accessories
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
461, 462, 463 - - - 18-24 18-24 18-24 18-24 18-24
414, 422, 429 - - - 12-17 12-17 12-17 12-17 12-17
425, 427 - - - 18-24 18-24 - - -
423E - - - 12-24 5-8 5-8 5-8 12-24
Wire Brushes
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
403, 404, 405 9-11 9-11 5-11 12-17 5-8 - - -
428, 442, 443 9-11 9-11 5-8 9-11 9-11 - - -
530, 531, 532 - 9-11 - 9-11 - - - -
535, 536, 537 9-11 9-11 - 9-11 9-11 9-11 - -
Sanding Bands and Discs
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
407, 408, 430, 431,
432, 438, 439, 440,
444
5-35 5-35 5-17 25-35 25-35 5-35 5-35 -
411, 412, 413 12-17 12-17 5-8 - 5-8 - - -
1600A012FX.qxp_8220 1/30/17 12:42 PM Page 29