SERVICE
a. Have your power tool serviced by a
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
SAFETY INSTRUCTIONS FOR
ALL OPERATIONS
SAFETY WARNINGS COMMON
FOR GRINDING, SANDING, WIRE
BRUSHING, POLISHING, CARVING
OR ABRASIVE CUTTING-OFF
OPERATIONS
a. This power tool is intended to function
as a grinder, sander, wire brush,
all safety warnings, instructions,
provided with this power tool. Failure
to follow all instructions listed below may
result in electric shock, re and/or serious
injury.
b. Do not use accessories which
and recommended by the tool
manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
c. The rated speed of the grinding
accessories must be at least equal to
the maximum speed marked on the
power tool. Grinding accessories running
faster than their rated speed can break
and y apart.
d. The outside diameter and the
thickness of your accessory must
be within the capacity rating of your
power tool. Incorrectly sized accessories
cannot be adequately controlled.
e. The arbour size of wheels, sanding
drums or any other accessory must
the power tool. Accessories that do
not match the mounting hardware of
the power tool will run out of balance,
vibrate excessively and may cause loss
of control.
f. Mandrel mounted wheels, sanding
drums, cutters or other accessories
must be fully inserted into the collet or
chuck. If the mandrel is insuciently held
and/or the overhang of the wheel is too
long, the mounted wheel may become
loose and be ejected at high velocity.
g. Do not use a damaged accessory.
Before each use inspect the accessory
such as abrasive wheels for chips
and cracks, sanding drum for cracks,
tear or excess wear, wire brush for
loose or cracked wires. If power tool
or accessory is dropped, inspect
for damage or install an undamaged
accessory. After inspecting and
installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and
run the power tool at maximum no-
load speed for one minute. Damaged
accessories will normally break apart
during this test time.
h. Wear personal protective equipment.
Depending on application, use face
shield, safety goggles or safety
glasses. As appropriate, wear dust
mask, hearing protectors, gloves
and workshop apron capable of
stopping small abrasive or workpiece
fragments. The eye protection must
be capable of stopping ying debris
generated by various operations. The
dust mask or respirator must be capable
of ltrating particles generated by your
operation. Prolonged exposure to high
intensity noise may cause hearing loss.
i. Keep bystanders a safe distance away
from work area. Anyone entering
the work area must wear personal
protective equipment. Fragments of
workpiece or of a broken accessory
may y away and cause injury beyond
immediate area of operation.
j. Hold power tool by insulated gripping
surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring. Cutting
accessory contacting a “live” wire may
make exposed metal parts of the power
tool “live” and could give the operator an
electric shock.
k.
24
To Next Page
Loading...
