ATTACHMENTS
functionality:
•
225
•
550
• Multipurpose cutting kit for controlled
565/566
•
568
•
575
•
576
• Detailer’s grip to have even better control
577
•
675
•
678
•
*) When using a new exible shaft for the
rst time, keep it in a vertical position for
two minutes with the tool running at high
speed.
NOTE: Not all attachments listed above
are standard included with the tool/kit
USE
GETTING STARTED
lower the spinning accessory lightly to the
work surface and allow it to touch the point
guiding the tool over the work using very little
with the tool rather than to do the entire job with
HOLDING THE TOOL
Always hold the tool away from your
face. Accessories can be damaged during
up to speed.
When holding tool, do not cover the
ventilation openings with your hand.
Blocking the ventilation openings could
cause the motor to overheat.
For best control in close work, grip the
ON/OFF
The tool is switched “ON” by the slide switch
ELECTRONIC MONITORING
Your tool is equipped with an internal
“soft start”, which will reduce the stresses that
are protected by cutting back the voltage to
VARIABLE SPEED SLIDE SWITCH
Your tool is equipped with a variable speed
30
To Next Page
Loading...
