•
BATTERY LEVEL INDICATOR
7
Your tool is equipped with advanced
and the battery pack should either be
a few seconds to allow the circuit to reset
CHARGING BATTERY PACK
Plug charger cord into your standard
inserted, the charger’s green indicator
charger is receiving power and the
press both battery release tabs and pull
When you insert the battery pack
into the charger, the charger’s green
indicates that the battery is receiving a
When the indicator light stops
The battery pack is fully charged and
When you begin the charging process
of the battery pack, a steady green light
of the battery pack is between 0°C
is nearing the end of its life and should
ACCESSORIES
ALWAYS TURN OFF THE TOOL BEFORE
CHANGING ACCESSORIES
Use only Dremel tested accessories. Be
sure to read the instructions supplied
with your Dremel accessory for further
information on its use. Handle and store
accessories carefully to avoid chipping
and cracking.
CHANGING ACCESSORIES
9
Collet nut
Shaft lock button
Wrench
*) not standard included
Press the shaft lock button and rotate
the shaft by hand until it engages the
Do not engage the shaft
lock while the tool is running.
28
To Next Page
Loading...
