during operation by sliding the switch back or
To select the right speed for each job, use
a practice piece of material.
OPERATING SPEEDS
Ad
applications require lower speeds to avoid wire
of the tool do the work for you when using
•
•
•
•
• If a high speed steel cutter starts to
vibrate, it usually indicates that it is
•
speeds, depending on the type of cutting
other suitable lubricant on the cutter to
NOTE: Increasing pressure on the tool is
not the answer when it is not performing
properly. Try a dierent accessory or speed
setting to achieve the desired result.
STALL PROTECTION
This tool has a stall protection feature built
on the tool for too long, or bind the bit in a
work piece, especially at high speeds, the
the tool continues to stall for longer than 5
MAINTENANCE AND CLEANING
!
NO USER SERVICEABLE PARTS
INSIDE. PREVENTIVE MAINTENANCE
PERFORMED BY UNAUTHORIZED
PERSONNEL MAY RESULT IN INCORRECT
CONNECTION OF INTERNAL WIRING AND
COMPONENTS WHICH COULD CAUSE
SERIOUS HAZARD.
Always wear
safety goggles when cleaning tools with
compressed air.
TO AVOID ACCIDENTS, ALWAYS
DISCONNECT THE TOOL AND/OR
CHARGER FROM THE POWER SUPPLY
BEFORE CLEANING
CERTAIN CLEANING AGENTS AND
SOLVENTS DAMAGE PLASTIC PARTS.
Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.
31
To Next Page
Loading...
