Insert the bit or accessory shank fully into
With the shaft lock engaged, tighten the
EZ TWIST INTEGRATED WRENCH
Aq
This nose cap has an integrated wrench
allowing you to loosen and tighten the collet
nut without the use of the standard collet
up the steel insert on inside of the cap
With the shaft lock engaged twist nose
cap counter clockwise to loosen the collet
Do not engage the shaft lock while
the tool is running.
Insert the bit or accessory shank fully into
With the shaft lock engaged twist nose
Screw the nose cap back into its original
DREMEL CHUCK 4486
rotate the shaft by hand until it engages the
Do not engage the shaft lock
while the tool is running.
With the shaft lock engaged use the wrench
necessary, continue loosening the chuck
the beginning of the working part of the
HELPFUL TIPS WHEN USING THE
DREMEL CHUCK
•
accessories, the collet and collet nut will
solution especially in heavier side load
•
cap or wrench to tighten the chuck
•
displaced causing the accessory to no
To reset the jaws, apply the following
procedure:
Press shaft lock button and tighten the
Continue to hand tighten the chuck until
Loosen the chuck, and reinsert a straight
Turn the tool by hand and observe if
With the shaft lock engaged, tighten
the chuck using the EZ Twist nose cap
or wrench to secure the accessory.
Turn the tool on to the lowest speed
BALANCING ACCESSORIES
true up or balance an accessory, slightly
loosen collet nut and give the accessory or
by the sound and feel if your accessory is
29
To Next Page
Loading...
