EasyManua.ls Logo

Dri-Eaz DRIZAIR 120 - User Manual

Dri-Eaz DRIZAIR 120
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
07-00022 B 10-96
OWNER'S MANUAL
WARRANTY • OPERATING INSTRUCTIONS • SAFETY
MAINTENANCE • SPECIFICATIONS • PARTS LIST
DRIZAIR 120 REFRIGERANT
DEHUMIDIFIER
This manual has important safety warnings and operating information.
Please read before using the dehumidifier and save for future reference.
PURCHASE DATE: ________________________________ SERIAL NO.: ______________________________________
DEALER: ____________________________________________________________________________________________________
DRI-EAZ PRODUCTS, INC. • 1320 Josh Wilson Road, Burlington WA 98233 • (360) 757-7776

Questions and Answers

  • R
    Rodney ParsonsAug 17, 2025
    Why is my Dri-Eaz DRIZAIR 120 Dehumidifier not operating?
    • J
      James JonesAug 18, 2025
      If your Dri-Eaz dehumidifier isn't operating, there could be a few reasons. First, ensure the unit is properly plugged in. Next, check the power outlet to confirm it's working. Finally, make sure the power switch on the dehumidifier is turned on.
  • M
    Meredith YoderAug 20, 2025
    What to do if my Dri-Eaz DRIZAIR 120 Dehumidifier compressor will not start?
    • J
      James HaleyAug 20, 2025
      If the compressor on your Dri-Eaz dehumidifier won't start, try these steps: 1. Turn the unit off and wait 5 minutes before restarting it. 2. Check for and replace or repair any broken or loose wires. 3. Ensure the room temperature is below 100° F (38° C) to prevent overload. 4. If the issue persists, the compressor may be faulty and require replacement or repair. 5. Use a volt/amp meter to check the relay.
  • J
    Jonathan SimsAug 22, 2025
    Why is my Dri-Eaz DRIZAIR 120 Dehumidifier fan blade not turning?
    • L
      lgreenAug 22, 2025
      If the fan blade on your Dri-Eaz dehumidifier isn't turning, check for these issues: 1. Look for any obstructions or bent fan blades and remove the obstruction or replace the fan blade. 2. Tighten the fan blade nut if it's loose. 3. Replace any loose or broken wires. 4. If the motor is burned out, replace the fan motor.
  • M
    Michelle CampbellAug 26, 2025
    What to do if my Dri-Eaz Dehumidifier has water overflowing while using pump-out?
    • N
      Nicholas VasquezAug 26, 2025
      If your Dri-Eaz dehumidifier is overflowing or leaking while using the pump-out feature, check these potential causes: Ensure the peristaltic pump is switched on. Inspect the wiring to the pump and check the motor. Replace the pump tubing or bearings/rollers if they have failed. Make sure the unit is level. Clear any obstructions or straighten any kinks in the drain hose or fittings.
  • C
    Christopher MasonAug 27, 2025
    What to do if my Dri-Eaz Dehumidifier pump is not functioning properly?
    • C
      clarkjoshuaAug 28, 2025
      If the pump in your Dri-Eaz dehumidifier isn't working right, it could be due to a cracked or distorted pump body, excessive shaft side play, worn rollers, or frozen rollers. In any of these cases, you should replace the pump, rollers or roller shaft.
  • B
    bakeramandaAug 30, 2025
    What to do if my Dri-Eaz Dehumidifier's water is overflowing the tray while using gravity drain hose?
    • D
      Dalton BradshawAug 30, 2025
      If water is overflowing the tray of your Dri-Eaz dehumidifier when using the gravity drain hose, ensure the unit is in a level position. Also, check the gravity drain hose for any kinks and straighten them out.
  • K
    Kelsey BeasleySep 1, 2025
    What to do if my Dri-Eaz Dehumidifier is operating but the room is not dry?
    • A
      anitathompsonSep 2, 2025
      If your Dri-Eaz dehumidifier is running but the room isn't drying, consider these factors: * Allow more time for the drying process to complete. * Improve air movement, potentially by using Dri-Eaz TurboDryers. * Reduce air infiltration into the area you're drying.
  • K
    Keith GardnerSep 4, 2025
    What to do if my Dri-Eaz Dehumidifier is not defrosting?
    • P
      Philip SmithSep 4, 2025
      If your Dri-Eaz dehumidifier isn't defrosting and has heavy frost or ice buildup, the following could be the reasons: a defective defrost control, a sensor that is improperly located or defective, or a defective bypass relay valve. Replace the defrost control, reposition or replace the sensor, or replace the bypass valve.
  • N
    Nicholas WagnerSep 6, 2025
    Why is my Dri-Eaz DRIZAIR 120 Dehumidifier continuously in defrost?
    • M
      Mark SanchezSep 7, 2025
      If your Dri-Eaz dehumidifier is continuously in defrost mode, it could be due to a defective defrost control, a room temperature that is too low, or a defective bypass relay valve. You may need to replace the defrost control or bypass valve, or increase the room temperature.
  • M
    Melissa WatkinsSep 9, 2025
    What to do if my Dri-Eaz DRIZAIR 120 Dehumidifier is collecting little water?
    • F
      farellanoSep 9, 2025
      If your Dri-Eaz dehumidifier is collecting very little water, it could be because the room air has already been dried to 45% relative humidity (Rh). Use a hygrometer to check the humidity. It could also be that the room temperature is too low, so try increasing it. Finally, restricted air movement through the unit could be the reason; increase airflow or clean out the coils.

Summary

Safety Information

Safety Warnings

Reduce risk of electrical shock, fire, or personal injury by following warnings.

Electrical Safety

Keep unit grounded, protect cord from damage, and keep electrical components dry.

Water and Child Safety

Avoid water exposure and keep children away from the operating unit.

Handling and Transport Safety

Handle with care, secure during transport, and do not modify the unit.

5 Year Limited Warranty

Maintenance Procedures

Specifications

Troubleshooting

Unit Not Operating

Steps to resolve issues when the dehumidifier does not turn on.

Compressor Issues

Diagnosing why the compressor will not start or run.

Airflow and Drying Problems

Solutions for fan not turning or room not drying effectively.

Coil and Moisture Issues

Addressing partial frost, no frost, or moisture on coils.

Water Overflow and Pump Issues

Troubleshooting water overflows and peristaltic pump malfunctions.

Dri-Eaz DRIZAIR 120 Specifications

General IconGeneral
BrandDri-Eaz
ModelDRIZAIR 120
CategoryDehumidifier
LanguageEnglish

Related product manuals