17
www.DrillDoctor.com
2.
3.
With Phillips-head screwdriver,
remove the two screws and
wheel retainer.
Use wrench supplied with your
Drill Doctor
®
to lock sharpening
wheel in place.
1.
Disconnect your Drill Doctor,
®
make sure machine is cool,
then remove wheel cover.
Reversing or Replacing Your Diamond
Sharpening Wheel
4.
Remove worn wheel by twisting
slightly and lifting wheel off
shaft. Install new wheel and
reinstall wheel retainer and
screws. Don’t over-tighten
mounting screws. Remove the
wrench and replace the wheel
access cover before turning on
the machine.
To Next Page
Loading...
