Error Possible Cause Remedy
Lift does not move * Battery is flat - Charge Battery
* Contacts on hand control - Unplug hand control; wipe
are contaminated contacts with a dry cloth and
plug hand control in again
* Hand control is not - Check plug-type connections
connected properly
Lift stops repeatedly * Battery is flat - Charge Battery
* Excessive lifting load - Reduce lifting load (note max.
Load ratings, see type label on
The bathlift)
* Jack plug not fully plugged - Check jack plug connection
Battery does not charge * Not connected to mains power - Connect battery charger
To mains power
* Contaminated contacts - Wipe contacts with dry cloth
Hand control does not * Jack plug not plugged in fully - Ensure jack plug is fully plugged in
function properly
Important remark concerning troubleshooting:
If it is not possible to operate the bathlift despite observing all of the above-mentioned information,
please
contact the specialist dealer who sold the device.
Notes concerning the disposal
The disposal and re-utilisation of old devices and
equipment has to be in compliance with the
relevant legal stipulations.
Devices subject to the Regulations concerning
electrical and electronic devices (elektroG) are
listed as medical products for professional users
B2B in the register of the foundation “elektro-Alt-
geräte-Register”.
Our registration number is DE 33275322
Re-use/Recycling
This product is suitable for re-use. The number of
re-
uses depends on the condition of the product.
The
manufacturer’s instructions have to be followed for
re-cycling. If necessary, these instructions will be
made available on request.
To Next Page
Loading...