Maintenance of the bathlift
The AquaJoy VALU£ is equipped with maintenance
free bearings and does not need any lubrication.
A periodic maintenance check of the bathlift has to
be conducted at least every 12 months. This check
includes a visual inspection of all parts in particular
load-bearing parts. It also includes all the necessary
function tests. If the inspection reveals any defects,
wear or other signs of damage, which might affect
the safety of the bathlift, the bathlift has to be
made inoperative until the defects are remedied.
All inspections have to be carried out by qualified
and trained personnel who have sufficient skills and
practical experience to perform such safety-
relevant work in an appropriate manner. These
qualified personnel have to remain independent
with regard to the tests and inspections being
carried out.
Please ask your bathlift specialist to arrange for
periodic inspections.
Your bathlift specialist has the necessary spare
parts lists and documentation available for you.
Please have repair work carried out by authorised
specialist dealers only.
Attention: The hand control must only be
opened by the bathlift manufacturer!
Cleaning
To keep the bathlift in a perfect condition it must
be
cleaned immediately after use (preferably by
showering it with hot water).
Carefully clean the bathlift under the shower after
each use. To clean the bathlift (without covers),
please use commercial disinfectants or bath
cleansers.
Maintenance of seat covers
The material of the removable covers is very
hygienic due to its smooth surface and antibacterial
properties.
The maintenance of the covers requires regular
cleaning, either by hand or in the washing machine
at 60°C (140° F). Please use a non-bio deter- gent
without any enzyme additives. Please note that
bath oils or other additives containing oils may lead
to discoloration of the covers. Discoloration can
also occur if the covers are not cleaned regularly.
Note: Discolorations of the covers are caused
by normal wear and are excluded from the
warranty.
The covers can be removed very easily for
cleaning.
Do not dry the covers in the tumble dryer, but
hang them on a line to dry.
In addition, the use of a commercial disinfectant
is recommended.
Please observe the manufacturer’s instructions!
Assembly of new cushion plugs for the
bathlift covers
First guide the new cushion plug through the
opening in the cushion (from top to bottom); then
press it into the washer at the underside.
To Next Page
Loading...