6. After bathing, press the UP button (yellow) on
the hand control to move the lift to a convenient
height (max. upper stop position).
Make sure that the side flaps do not get caught
on bath fittings or handles.
7. Now the person bathing can leave the bath by
sliding sideways from the seat surface.
The AquaJoy VALU£ switches off automatically
after approx. 30 minutes. If you wish to switch off
the bathlift manually, press red button on the hand
control (the control lamp will go out).
Notes:
When moving up or down, lean against the
backrest and leave your hands on your lap.
If the lift has to remain in the bath, the hand
control should be disconnected to prevent the
battery from discharging.
Removing the lift from the bath
Using the hand control, first move the bathlift to its
bottom position and allow the backrest to tilt
back
until the drive stops automatically in its end
position. Take note that the backrest does not
touch the wall of the bathtub. Now disconnect the
hand control.
1. Fold in the side flaps, so that they rest on
the seat surface.
2. Use the handles of the drive unit to fold
the drive unit down.
To Next Page
Loading...