To Next Page
E
Elizabeth MclaughlinNov 2, 2025
What to do if Drive 15302LW Medical Equipment bed movement does not occur when the pendant control button is pushed?
- QqcordovaNov 2, 2025
If your Drive Medical Equipment bed isn't moving when you press the pendant control button, there could be several reasons. First, the adjustment might already be at its maximum or minimum level. Second, the bed might not be plugged into the wall outlet, or the backup 9V battery may be missing or dead; ensure the bed is plugged in. Third, repeated or simultaneous adjustments may have tripped the thermal protection overload; allow the bed to sit for several minutes (up to 30) to reset. Fourth, the pendant cord could be damaged; check for damage and stop using the bed until the cord is replaced. Fifth, the pendant connection may be loose; reconnect it to the motor housing following the instructions on page 19. Finally, the bed may be overloaded or obstructed; check the load and look for any ...
General
