18
Power/Direction Switch
To allow the Powerstroll to move forward press the front of the button (marked
“I”).
To allow the Powerstroll to move backwards press the rear of the button
(marked “II”).
To switch o the Powerstroll press the button so the switch is in the middle
position (marked “0”).
Please note there is a 2-second delay when starting up the Powerstroll before
the wheel will move. Wait 2 seconds before squeezing the trigger.
Always ensure the Powerstroll is switched o when not in use.
• Do not turn the power o whilst moving as this will lead to
an emergency stop and possible risk of damage or injury.
• When at rest, power down your Powerstroll to prevent
unintended motion.
Warning
Throttle lever
Squeeze the trigger to propel the Powerstroll. The more the trigger is
squeezed, the faster the Powerstroll will travel. Release the trigger to stop the
Powerstroll.
Speed Adjustment Dial
Turn the dial clockwise to increase the maximum speed of the Powerstroll.
Turn the dial anticlockwise to reduce the Powerstroll’s maximum speed.
Power Indicator LED
This is lit green when the Powerstroll is switched on.
Tightening Handles
The right-hand is used to secure the clamp holding the handset to the push
handle. The left-hand secures the handset at the required angle.
Do not adjust the speed settings whilst moving as this could
result in loss of control. Do not set the highest speed whilst
moving indoors.
Warning
To Next Page
Loading...
