Drive DeVilbiss Lightweight Powerstroll - Charging & Preparing for Use; Installation

13
8. CHARGING & PREPARING FOR USE
8.1 Installation
• Before preparing the Powerstroll, ensure these instructions
have been read and fully understood.
• Prepare the Powerstroll in a dry, indoor environment.
• Only competent persons are to prepare the Powerstroll for
use. If in doubt, contact Drive DeVilbiss Healthcare Ltd.
• Ensure a risk assessment in line with local health and safety
policy is undertaken to ensure that sta are not put at risk
when performing assembly activities.
Warning
Handset Installation
• Loosen both knobs on the
handset.
• Squeeze the crocodile clip on
the handset and apply to the
push handle as shown. Secure
the clip by turning the outer knob
clockwise.
• Tilt the handset to the required
angle then tighten the inner knob
clockwise to secure.
Bracket Installation
• Install both brackets on the bottom
horizontal tubing of the wheelchair,
using a 5mm Allen Key (as shown
right)
• Ensure that the screws are
suciently tight and that the
brackets do not rotate on the
tubing. Ensure that the holes on
each bracket are horizontal and
that the brackets are aligned with
each other.