7 . I N S P E C T I O N A N D M A I N T E N A N C E
7.7 ASSEMBLING THE SCOOTER
Suggestion
The assembly process is essentially the disassembly process in reverse. First study the text
and photographs in the disassembly procedure before re-assembling the scooter.
1. Position the front and rear sections of PHOENIX HD 3/PHOENIX HD 4.
2. Align the lower curved locking brackets of the front section with the corresponding
pegs on the front of the rear section.
3. Plug in electrical connector to connect the front and rear sections.
4. Holding the lower seat post, slowly pivot the rear section forward until the curved
locking brackets are fully connected on to the top rear pegs.
5. Loosen tiller adjustment knob, raise the tiller to the desired position, and then tighten
the tiller adjustment knob.
6. Reinstall the upper seat post at the desired height. Secure with the locking pin and
tighten the seat post knob.
7. Reinstall the batteries by lowering it in to place. Then turn the remove switch to lock.
8. Replace the seat and rotate it until it locks into its correct position.
Warning
After assembling the PHOENIX HD 3/PHOENIX HD 4, make absolutely certain the tiller
adjustment knob is fully tightened.
To Next Page
Loading...
Need help?
General
