SETUP
MONITORING BATTERY ENERGY LEVEL:
Disposal of Batteries: Do not dispose of used batteries in the household waste. Contact a public waste disposal
authority for proper disposal instructions.
- Blinking red light: Low Battery energy level. Replace batteries.
STEP 1: Remove the battery cover by pressing the clip on the top of the unit
and pull the cover out.
STEP 2: Remove old batteries from the compartment and discard properly.
STEP 3: Insert 2 "AA" Alkaline with the polarity as indicated on the holder.
STEP 4: Insert the battery cover back onto the unit and push until the retaining
clip snaps into place.
NOTE:
The SmartDose is packaged with batteries inside. A special seal is used at the positive terminal to
prevent battery oxidation. If it has not already been
removed byyour Home Care Provider, be sure to remove
the seal before using the unit for the first time.
INSTALLING/CHANGING ALKALINE BATTERIES:
The SmartDose uses advanced technology that prolongs battery life through
efficient power use. With normal use of four (4) hours per day at any setting,
your batteries should last a minimum of
1 year.
Two (2) "AA" alkaline batteries are included in your SmartDose.
Follow these easy steps to install or change batteries when needed:
The SmartDose is equipped with a visual low battery information signal that alerts you when a battery change is
needed. The following signals will occur as your batteries become depleted:
- Solid red light: Batteries are dead.
To Next Page
