Instruction BookletST-3
OPERATING YOUR SCOOTER
9
Before beginning your journey with your new scooter, make sure that scooter is on a level
surface and clear of any obstacles. Although your scooter is able to climb slopes, it is safer
to practice on a level surface.
This scooter has an automatic braking system. Release the thumb
control and brakes will engage.
•adjust seat height and location.
•adjust armrest width to comfortable position.
•adjust the tiller angle.
1.Before operating your scooter, check the following:
•free-wheel lever is engaged.
•speed dial knob is at picture of turtle.
2.Sit on scooter and turn on the key. All Battery gauge LED lights should lit.
The self-diagnostic warning light should not be flashing.
3.When your hands rest comfortably on handlebars, the thumb levers should be within
reach. Right lever moves the scooter forward; left one moves it in reverse. When you
release the thumb lever, the scooter will stop.
4.Steering the scooter is done by turning the whole tiller in the direction of intended travel.
5.Practice driving the scooter in an area with no obstacles to familiarise yourself with the
turning and starting/stopping operations Start at the slowest speed and drive forwards
and backwards. As you become comfortable you can increase the speed by turning
the speed dial towards the picture of the rabbit.
6.If the only two-battery gauge LED lights are lit, you should recharge the batteries as
soon as possible.
7.If scooter stops and does not function, locate the circuit breaker on top of the battery
pack. Push it and try the scooter again.
8.When you driving the scooter,
turn off the key before getting off.
9.When the scooter is not being used the batteries should be placed on charge.
See CHARGING THE BATTERIES on page 15.
You could make the following adjustments to increase your comfort when driving：
To Next Page
Loading...
Need help?
General
