Instruction BookletST-3
18
TROUBLESHOOTING
Flash Description Meaning
1
2
3
4
5
6
7
8
9
10
Battery Low
The batteries are running low.
•Recharge the batteries
Low Battery Fault
The batteries have run out of charge
Recharge the batteries
High Battery Fault
Battery voltage is too high. This may occur if
overcharged &/or traveling down a long slope.
•If traveling down a slope, reduce your speed to
minimize the amount of regenerative charging.
•Check the battery and associated connections
and wiring
Current Limit Time-out
The motor has been exceeding its maximum current
rating for too long. This may be due to a faulty motor.
•Check the motor and associated connections
and wiring.
•Turn the controller off, leave for a few minutes
and turn back on again.
Park Brake Fault
Either a park brake release switch is active or the
park brake is faulty.
•Check the park brake and associated connections
and wiring
•
Ensure any associated switches are in their correct
positions.
Thumb Lever OONAPU
The Thumb Lever is out of neutral when turning
the controller on.
•Ensure the thumb lever is in neutral when turning
the controller on.
•The Thumb Lever may require re-calibration.
Speed VR Fault
The thumb lever, speed VR, SRW or their associated
wiring may be faulty.
•
Check the thumb lever and speed VR and associated
connections and wiring.
Motor Voltage Fault
The motor or its associated wiring is faulty.
•Check the motor and associated connections
and wiring.
Other error
The controller may have an internal fault.
Check all connections & wiring.
Push/Rollaway Fault
The scooter has exceeded the Push or Rollaway
speed limits.
•Turn the controller off and then on again.
To Next Page
Loading...
Need help?
General
