Instruction BookletST-3
14
RE-ASSEMBLING YOUR SCOOTER
To assemble scooter, you can repeat disassembly directions in reverse. Abbreviated
directions are given below. Refer to Figures on pages 12 - 13 to locate the parts.
1.
Rotate Hand Wheel Tiller Angle Adjustment clockwise to adjust tiller and counterclockwise
to lock tiller into its upright position.
2.Pivot rear section until it is standing vertically.
3.
Hold seat receiving post to align curved locking brackets of front section with corresponding
bar on rear section.
4.Hold seat receiving post slowly pivot rear section forward until release lever locks.
5.Reinstall battery pack in battery compartment.
6.Replace front basket.
7.Replace seat and tighten seat lock knob to secure.
Figure 11Figure 11
To Next Page
Loading...
Need help?
General
