EasyManuals Logo

Drive ST3 User Manual

Drive ST3
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Instruction BookletST-3
You can also charge your batteries on & off the scooter
16
1. Switch your scooter off at tiller main switch.
2. Remove battery pack from scooter.
3. Please refer to above charging procedure for following actions.
Keep in mind these rules
Allow charging until the charger light turns green, for fully charged battery please wait for
another hour then disconnect the charger.
Fully charged time is approximately 7 hours(according to discharge's depth) Do not
continuously charging for over 20 hours.
Fully charge batteries at least once a month; more if you use scooter regularly. Charge
after each trip exceeding 3 kilometers / 1.86 miles.
If storing your scooter for one month or more, make sure that batteries are fully charged.
Upon returning, charge them again before using scooter.
Batteries will only give maximum performance after scooter has been used, and the batteries
have been recharged up to 10 times.
For Safety, please follow guidelines below
1.DO NOT use the charger if power cord is damaged.
2.
DO NOT use an extension cord when charging your batteries. A risk of fire and/or electric
shock could occur.
3.DO NOT take apart charger, as this will void warranty.
4.
Never attempt to open battery pack. If it is necessary to replace batteries, have a certified
technician to handle all repairs.
Figure 13Figure 13
ISSUE 1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Drive ST3 and is the answer not in the manual?

Drive ST3 Specifications

General IconGeneral
BrandDrive
ModelST3
CategoryScooter
LanguageEnglish

Related product manuals