DROCON X708 - Flight Functions and Installation; One Key Return Function

9
When you take off,make sure
that your front is the aircraft's
front; turn the left control
stick to the left, the aircraft will
turn left.
When you take off,make sure
that your front is the aircraft's
front; turn the left control
stick to the right, the aircraft
will turn right.
When you take off,make sure
that your front is the aircraft's
front; turn the right control
stick to the right, the aircraft
will fly rightward.
When you take off,make sure
that your front is the aircraft's
front; turn the right control
stick to the left, the aircraft
will fly leftward.
When you take off,make sure
that your front is the aircraft's
front; push down the right
control stick, the aircraft will
fly backward.
When you take off,make sure
that your front is the aircraft's
front; push up the right control
stick, the aircraft will fly forward.
Protection frame and propeller installation
2.Affix the protection frame
by screwing clockwise.
3.Fasten the propeller by
turning the screws
clockwise.
1.There are 3 interfaces on
each motor cabinet. Insert
the frame plugs into the
interfaces.
One key return:
When the drone is flying in headless mode, if the one key return button, the drone will fly towards the user.
If the one key return button is pressed again or the forward /backward control stick used, the drone will exit
the one key return function.
Remarks:
●Drone calibration is needed when the drone is about to fly in the headless mode. When verifying the flight
direction, the drone ought to positioned with its nose pointing straight ahead and the tail pointing towards
user. The must always face the direction in which the drone nose is pointing .
●When the drone is flying in headless mode, if the flight direction is inconsistent with the user’s operational
command or there are directional deviations, please stop flying and re-calibrate the drone immediately.