261
Checks
DS5_en_Chap09_verifications_ed02-2015
F After emptying the bottle, wipe away any
spillage around the tank filler using a damp
cloth.
F Refit the blue cap to the tank and turn it a
6
th
of a turn clockwise, to its stop.
F Refit the black plastic blanking plug,
clipping it in place.
F Lower the boot floor and close the tailgate.
Important: if your vehicle's
AdBlue
®
tank is completely empty -
which is confirmed by the alert
messages and the impossibility of
starting the engine - you must add at
least 3.8 litres, so two 1.89 litre bottles.
If any additive is split or splashed, wash
immediately with cold water or wipe
with a damp cloth.
If the additive has crystallised, clean it
off using a sponge and hot water.
Important: when topping up after
running out of additive, signalled
by the message "Top up emissions
additive: Starting prevented", you must
wait for approximately 5 minutes before
switching on the ignition, without
opening the driver's door, unlocking
the vehicle, placing the key of the
"Keyless Entry and Starting" system
inside the vehicle or inserting the
electronic key in the reader.
Switch on the ignition, wait for
10 seconds, then start the engine.
Never dispose of AdBlue
®
additive
bottles in the household waste. Place
them in a special container provided
this purpose or take them to your
dealer.
To Next Page
Loading...
Need help?
General
