Series PC Manual V 1.0 - Rev. 3 – 03/01/01 DS Europe
35
4 Low Limit1 Cursor 1 ZERO reference @0L1Lzzzzzz
5 High Limit 1 Cursor 1 FULL SCALE reference @0L1Hwwwwww
6 Minimum Calibration 1 Internal count value minimum 1 @0T1Z
7 Maximum Calibration 1 Internal count value maximum 1 @0T1F
8 A/D Configuration A/D converters bit configuration @0Dbbbbbbbb
9 Serial address Transducer serial ID @0Ax
Table 4: table of parameters in memory
Example:
@ 0 X 0 <cr>
In the example the contents of the 0 parameter are read (cursor 0 ZERO refernence)
Note: “xxxxxx”, “yyyyyy”, “zzzzzz”, “wwwwww” are 6- figure subjects of commands used to
program the transducer configuration.
To Next Page
Loading...