Series PC Manual V 1.0 - Rev. 3 – 03/01/01 DS Europe
38
16. TESTS FOR APPLICATION OF CE MARK
16.1. TEST CENTRE AND LIST OF TESTS
The tests are carried out at the internationally recognised “Competent Body” Test Centre.
For compatibility tests the strictest legislation for industrial applications have been applied:
EN 50081-2 (for emission phenomena ) and EN 50082-2 (for immunity phenomena).
They include the following principle regulations: EN 55011; ENV 50140; ENV 50141 (DC
I/O); ENV 50141 (signal: lines); EN 61000-4-4 (DC I/O); EN 61000-4-4 (signal: lines); EN
61000-4-2; EN 61000-4-8; EN 61000-4-5; ENV 50204.
16.2. TEST RESULTS AND LAW ON CONFIDENTIALITY
All the tests gave positive results.
The Test Centre and EC Regulations impose that all documents and test data therein
remain confidential and that they can neither be published nor photocopied, and are only
available for consulting purposes in our factory for approved Authorities.
GUARANTEE
The numerous mechanical and electrical controls carried out during manufacturing and
final testing ensure that the units delivered are free of defective material, machining and
operational defects.
Any units which prove to be defective, despite the above mentioned controls, shall be
repaired or replaced free of charge by DS Europe, on the conditions that the units have
been subject to normal or correct use and in any accordingly with the use described in the
herein manual, and that such units shall be delivered to the DS Europe office, by the
Customer, (who will have to forfeit the costs for the relative transport, insurance, customs
etc.), within 6 months from the sales shipment from DS Europe to the Customer.
The Customer is to be fully aware, exonerating DS Europe from any responsibility with
regard to such, that the returned units in as much as seemingly defective might be
tampered with in order to carry out necessary controls; so, where we are dealing with units
such as these and hence not covered by above guarantee, DS Europe will return the units,
at the Customer’s expense, the units which, following the execution of the above
mentioned controls, may no longer be intact.
Manual of instructions N°280200-I. All the information in this manual the information, or
any part thereof, is confidential and cannot be made widespread without express written
authorisation from DS Europe srl.
This manual, even after sales of transducer, is only handed over for viewing purposes and
remains the property of DS Europe.
To Next Page
Loading...