DS PC Series - Calibration Methods; Calibration with Push Buttons

Series PC Manual V 1.0 - Rev. 3 – 03/01/01 DS Europe
4
11. WARNING LEDS ...........................................................................................................................................24
11.1. GREEN LED .................................................................................................................................................24
11.2. YELLOW LED..............................................................................................................................................24
12. PROTECTION FROM ELECTROMAGNETIC EXTERNAL INTERFERENCE.......................................25
13. CALIBRATION METHODS ...............................................................................................................................25
13.1. MECHANICAL AND ELECTRICAL MEASURING FIELD COINCIDENCE: ........................................27
13.2. CALIBRATION WITH PUSH BUTTONS:..................................................................................................27
13.2.1. “0” cursor ............................................................................................................................................28
13.2.2. “1” cursor ............................................................................................................................................28
ONE OF THE ADVANTAGES OF USING THE SERIES PC IS THE POSSIBILITY TO BE ABLE TO USE ONLY ONE PART OF THE
NOMINAL STROKE OF THE TRANSDUCER WITHOUT HAVING TO ALTER THE STABILITY AND RESOLUTION OF THE
TRANSDUCER
.................................................................................................................................................................30
12.3 REMOTE CALIBRATION ...........................................................................................................................30
14. SERIAL COMMUNICATIONS PROTOCOL...................................................................................................31
14.1. PROTOCOL FORMAT.................................................................................................................................31
14.2. COMMAND MESSAGE STRUCTURE.......................................................................................................31
14.3. ACCEPTED COMMANDS...........................................................................................................................32
14.3.1. COMMAND “A” .................................................................................................................................32
14.3.2. COMMAND “D”.................................................................................................................................32
14.3.3. COMMAND “L” .................................................................................................................................33
14.3.4. COMMAND “R” .................................................................................................................................33
14.3.5. COMMAND “V” .................................................................................................................................33
14.3.6. COMMAND “T” .................................................................................................................................34
14.3.7. COMMAND “X” .................................................................................................................................34
14.4. TRANSDUCER REPLIES ............................................................................................................................36
15. DECLARATION OF CONFORMITY................................................................................................................37
16. TESTS FOR APPLICATION OF CE MARK....................................................................................................38
16.1. TEST CENTRE AND LIST OF TESTS........................................................................................................38
16.2. TEST RESULTS AND LAW ON CONFIDENTIALITY.............................................................................38
IMPORTANT: always bench check the transducer operational performance before
installation.