DSC GS3055-IG - Contact ID and GPRS Configuration; Contact ID Page; Telephone Numbers to Call; Events Description

13
G
Contact ID Page
This page will allow you to set up the Contact ID function.
Telephone numbers to call
Four telephone numbers of up to 20 digits (digits and + signs).
This Device will try each telephone number 3 times before considering a call unsuccessful and quitting.
,,
,,
, The Contact ID Codes will be sent to the first number (with Contact ID reporting protocol) that answers the call.
Events description
z Customer Code - type in a 4 character code (accepted values: digits and the letters A, B, C, D, E and F).
To send the SMS it is necessary enter a Customer Code (e.g. 1111) for the relevant event.
z Event Code - type in the Contact ID to be transmitted when the respective event occurs.
z Send - select (tick) the events to be sent.
Contact ID default
Click on this button to assign the following Event Codes to the events manage by this Device.
Event Description Event Code Sur-Gard System III / II Description
Input 1 activation E 110 FIRE ZONE 001
Input 1 Restoral: R 110 FIRE ZONE 001
Input 2 activation: E 120 Panic Alarm ZONE 002
Input 2 Restoral: R 120 Panic Alarm ZONE 002
Input 3 activation: E 130 Burglary ZONE 003
Input 3 Restoral: R 130 Burglary ZONE 003
Input 4 activation: E 150 24 HOUR (AUXILIARY) ZONE 004
Input 4 Restoral: R 150 24 HOUR (AUXILIARY) ZONE 004
PSTN Line down: E 351 TELCO 1 FAULT 000
PSTN Line Restoral: R 351 TELCO 1 FAULT 000
12V INPUT LOSS: E 337 EXP. MOD. DC LOSS 000
12V INPUT RESTORAL: R 337 EXP. MOD. DC LOSS 000
LOW BATTERY ALERT: E 338 EXP. MOD. LOW BAT 000
LOW BATTERY RESTORAL: R 338 EXP. MOD. LOW BAT 000
PERIODIC REPORT: E 603 Periodic RF Xmission 000
GSM UNIT ACTIVATION: R 552 Radio Xmitter Disabled 000
GSM INTERNAL BUFFER FULL: E 624 EVENT LOG OVERFLOW 000
FTC EVENT: E 354 FAILURE TO COMMUNICATE 000
FTC RESTORAL: R 354 FAILURE TO COMMUNICATE 000
Send over GPRS
If this option is enabled, this Device will only communicate Contact ID events via the GPRS network.
Periodic Reports
This Device can be programmed to send Periodic Contact ID reports. This section will allow you to select the Date and Time of the first
periodic report and the Interval between reports.
If the external power supply (connected to terminals [+12V]) and battery power supply drop at the same time, the Device
must be re-programmed after the power supply is restored, otherwise the time set for the Periodic Report could NOT be
respected.