S Y S T E M I N T R O D U C T I O N
4
PC5904 Central Station Talk/Listen Module PC5904 Central Station Talk/Listen Module
PC5904 Central Station Talk/Listen Module PC5904 Central Station Talk/Listen Module
PC5904 Central Station Talk/Listen Module
can be used with the PC5928 audio interface module,the PC5936 audio
interface module, and the PC5937 eight-port expansion module for talk/listen in capability
.
1.2.10 PC5400 Printer Module
This PC5400 printer module will allow the panel to print out all events that occur
on the system to any serial printer. All events will be printed with the partition,
time, date and the event that occurred. (See PC5400
Installation Manual
for details.)
1.2.11 GSM1000 Cellular Communicator
The GSM1000 cellular communicator provides an efficient, cost-effective method for
adding cellular back up. The unit comes in its own cabinet with antenna and requires a
separate battery and transformer (See Section 5.28
“GSM1000 Cellular Communica-
tor”
)
.
1.2.12 Downlook Support: PC5108L and DLM-4 v1.0L
The PC5108L will expand the control panel’s zone capability by adding eight fully programmable zone inputs. The
module will also act as an interface between the DLM-4L v1.0 video transmission module and the PC5015 v2.2 alarm
control panel. The PC5108L is also an 8-camera video switcher.
For more information on either module, see their respective installation manuals.
PC5108L DLM-4L v1.0
1.2.13 PC5700 Fire Module
This is a zone expansion module with four general purpose zone inputs, two Class A
supervisory waterflow zone inputs, ground fault detection and dual-supervised
telephone line inputs.
1.2.14 Cabinets
Several different cabinets are available for the PC5015 modules. They are as follows:
PC5003C main control cabinet for the PC5015 main panel. Dimensions 288mm x 298mm x 78mm / 11.3” x 11.7” x
3” approximately.
PC5002C Cabinet to house the PC5204 power supply output module. Dimensions 213mm x 235mm x 78mm / 8.4”
x 9.25” x 3” approximately.
PC5004C Cabinet to house the Escort5580 module and PC5400 printer module. Dimensions 229mm x 178mm x
65mm / 9” x 7” x 2.6” approximately.
PC5001C Cabinet to house the PC5108 zone expander module and the PC5208 eight low current output module.
Dimensions 153mm x 122mm x 38mm / 6” x 4.8” x 1.5” approximately.
PC5001CP Plastic Cabinet to house the PC5108 zone expander module and the PC5208 eight low current output
module. Dimensions 146mm x 105mm x 25.5mm / 5.75” x 4.2” x 1” approximately.
1.2.14 Backplates
There are two different backplates available for keypads to locate an audio station next to the keypad:
PC55BP1 BackplatePC55BP1 Backplate
PC55BP1 BackplatePC55BP1 Backplate
PC55BP1 Backplate: This backplate is to be used when an audio station is to be
located next to a keypad. Dimensions 208mm x 115mm x 18mm / 8.2” x 4.5” x
0.25” approximately.
PC55BP2 Backplate: PC55BP2 Backplate:
PC55BP2 Backplate: PC55BP2 Backplate:
PC55BP2 Backplate: This backplate is to be used when an audio station is to be
located next to a keypad. In addition the backplate will allow you to mount a PC5108
zone expander module or the PC5208 eight low current output module. Dimensions
208mm x 115mm x 18mm / 8.2” x 4.5” x 0.7” approximately.
1.3 Out of the Box
Verify that the following equipment is included in your system:
• one PC5015 circuit board
• one set of manuals (
Installation Manual
, one
Programming Worksheet Manual
and one
Instruction Manual
for the
end user
• one hardware pack consisting of:
- five plastic circuit board standoffs - one 2200 Ohm (2.2K) resistor
- seventeen 5600 Ohm (5.6K) resistors - one 1000 Ohm (1K) resistor
To Next Page
Loading...
