DSC Power 864 - Page 17

Intrusion
(Burglary)
Alarms
Viewing
Memory
A steady bell or siren indicates an intrusion alarm.
To silence the alarm:
1. Enter your [access code],
2. If the alarm was unintentional, call your central station or local authorities immediately
to avoid an unnecessary response.
3. Check the alarm memory display to see which zone caused the alarm.
Once the source of the alarm has been corrected, the system will return to the Ready
state.
NOTE: Your LCD5500Z keypad has the capability to display "Communications Can¬
celled" if you have central station supervision and if the alarm occurred within a set
communication cancel window. For more information about this feature, ask your
installer.
The alarm memory display shows you which zone (detector) caused the alarm. The alarm
memory is cleared each time the system is armed. Any alarms showing on the system have
occurred only during the last armed period.
CAUTION: If you return and find that an alarm has occurred while you were
away, it is possible that an intruder is still on the premises. Go to a nearby safe
location, and call your central station or the local authorities to investigate.
LCD5500Z Keypads
If an alarm occurred while the system was armed, LCD5500Z keypads will display "View
Memory <> Zone X".
1. Use the C<][E^ keys to v ' ew which zone(s) caused the alarm.
2. To cancel the alarm memory display, press ©.
LCD5501Z Keypads
If an alarm occurred while the system was armed, the Memory indicator will flash, and the
keypad will scroll through the zones that were in alarm for 30 seconds after the system has
been disarmed.
1. To cancel the alarm memory display, press © during the 30-second display.
2. After the 30-second period is over, the system will return to the Ready state, but the
Memory indicator will be ON. To view alarms in memory, press ® ©. The display will
scroll the numbers of the zone(s) that were in alarm.
PC55XXZ Keypads
If an alarm occurred while the system was armed, the Memory light and the zone light cor¬
responding to the zone that caused the alarm will flash for 30 seconds after the system has
been disarmed.
1. To cancel the alarm memory display, press © during the 30-second display.
2. After the 30-second period is over, the system will return to the Ready state, but the
Memory light will be ON. To view alarms in memory, press ©@. The zone light(s) of
the zone(s) that were in alarm will flash.
NOTE: Troubles will not display while the system is displaying alarms in memory.