SMS Command and Control
Certain functions can be performed on the alarm panel by remote using SMS text messages. In addition, the system sends
SMS messages to confirm commands. SMS programming options are accessed through programming section [851]. The
security system only responds to SMS messages sent from designated phone numbers (programmed in section [851]>
[311]-[328]).
SMS Commands
l Stay arm the system l Deactivate command output 1
l Away arm the system l Deactivate command output 2
l Night arm the system l Deactivate command output 3
l Disarm the system l Deactivate command output 4
l Activate command output 1 l System status request
l Activate command output 2 l Alarm memory request
l Activate command output 3 l Zone bypass
l Activate command output 4 l Zone unbypass
SMS text messages mustbe formatted as follows:
<f
unct
ion
name><s
pa
c
e><partit
ion
#><s
pa
c
e><acc
ess
code>
(e.g., Stay Arm partition 1 1234). Once the command is received and executed by the alarm system, a confirmation text mes-
sage is received.
NOTE: For more information about SMS commands and control functions, refer to the Neo 1.1 User Manual.
Communicator Status LEDs
The communicator has four on-board LED indicators. These include one yellow trouble LED, one red network connection
status LED and two green signal strength LEDs. The LED meaning is described in this section.
Yellow Trouble LED
This yellow LED will flash to indicate a trouble on the unit. The number of flashes indicates the type of trouble, refer to the
table below for trouble conditions.
Table 5: Yellow Trouble Status LED
# of
Flashes
Trouble
# of
Flashes
Trouble
2 Panel Supervision Trouble 7 Receiver Not Available Trouble
4 Not Applicable 8 Receiver Supervision Trouble
5 Cellular Trouble 9 FTC Trouble
6 Ethernet Trouble 12 Module Configuration Trouble
NOTE: Only the highest priority trouble (2 flashes is the highest priority trouble) is indicated. When this trouble is restored,
the next highest trouble is indicated, if present. This will continue until all troubles have been cleared (yellow LED is
not flashing).
The following section describes the conditions associated with each trouble:
16
To Next Page
Loading...
Need help?
General
